Thingiverse
Window Stopper
von Helyon
15
Downloads
25
Likes
0
Makes
A simple window stopper, for keeping your windows fully open while ventilating your room
The shape helps to keep the stopper in place, even if the windows is moving due to wind. It can be uses symmetrically.
I printed it in Armadillo TPU (https://ninjatek.com/shop/armadillo), a very hard TPU, but I think any material can be used.
To prevent damages on your window, while trying to close it with the stopper inside (this will happen sometimes at the beginning
It is 4cm wide at the thinnest point
UPDATE:
I made the outer wall a little bit thicker, so that when printed in TPU, it won't squeeze together but rather slide a little bit better up and down (hopefully)
The shape helps to keep the stopper in place, even if the windows is moving due to wind. It can be uses symmetrically.
I printed it in Armadillo TPU (https://ninjatek.com/shop/armadillo), a very hard TPU, but I think any material can be used.
To prevent damages on your window, while trying to close it with the stopper inside (this will happen sometimes at the beginning
It is 4cm wide at the thinnest point
UPDATE:
I made the outer wall a little bit thicker, so that when printed in TPU, it won't squeeze together but rather slide a little bit better up and down (hopefully)
Helyon veröffentlicht auch auf
18 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
