Thingiverse
Wire clips
von Dmill541
2
Downloads
1
Likes
0
Makes
I made these for my printer I rewired and extended most of the wiring. they will clip on the inside of the thin side of the T-slot rail one leg on opposite sides. Or if you like they will wedge into the wide side of your T-slot, one leg in each grove side by side. both ways are secure. I recommend using PETG at least 20% infill. And as always enjoy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
