Thingiverse
wire cover
von Robocut
4
Downloads
10
Likes
0
Makes
I needed a cover for the led-driver and wires in my spotlight installation
came up with this. about 200 mm high, fits in my anycubic i3 Mega, but check the cabling from printhead at max height before printing...
I printed with PLA Z at 0.2
came up with this. about 200 mm high, fits in my anycubic i3 Mega, but check the cabling from printhead at max height before printing...
I printed with PLA Z at 0.2
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!