Thingiverse
Wire holder
von Chainsaw675
5
Downloads
3
Likes
0
Makes
I needed something simple to accurately cut 600 small gauge wires.
Thread some hat elastic through the holes and tie off on the side with the five holes.
Double sided tape to hold down.
Feed wire from spool under elastic.
Drag out to length required, use cutters on the bottom side of the opening in the middle of the part,.
The wire end is held ready to grab and drag out again.
Thread some hat elastic through the holes and tie off on the side with the five holes.
Double sided tape to hold down.
Feed wire from spool under elastic.
Drag out to length required, use cutters on the bottom side of the opening in the middle of the part,.
The wire end is held ready to grab and drag out again.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!