Thingiverse
Wire Mount
von Creater
180
Downloads
140
Likes
0
Makes
This is a mount for three wires. You can easily clip them in without falling back out when you pull them.
Dimensions: 100 x 35 x 16 mm. The holes have a diameter of 5 mm.
Version 1.3 is without holes so you can use double sided tape.
Let me know if the current version works well for you, thanks.
Dimensions: 100 x 35 x 16 mm. The holes have a diameter of 5 mm.
Version 1.3 is without holes so you can use double sided tape.
Let me know if the current version works well for you, thanks.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
