Thingiverse
Wire Shelf Spool Hanger
von Spirko
20
Downloads
10
Likes
0
Makes
Wire Shelf Spool Hanger
The shelf above my Creality Ender 3 V2 printer is a convenient place for hanging the spool currently being used. At first, I tried to zip-tie the spool mount to some angle brackets, but it kept moving.
In the picture, the hanger is marked by the red arrows.
It's narrow enough to be installed from underneath (as long as nothing is on that part of the shelf). A wide section has 45° overhangs leading to it, so it printed without support for me. You could add support to the build plate.
Inclides OpenSCAD source file.
(Yes, that's a side-mounted foot on the printer, for accessing the motherboard and power supply. Maybe I'll post the bracket and foot for that project.)
The shelf above my Creality Ender 3 V2 printer is a convenient place for hanging the spool currently being used. At first, I tried to zip-tie the spool mount to some angle brackets, but it kept moving.
In the picture, the hanger is marked by the red arrows.
It's narrow enough to be installed from underneath (as long as nothing is on that part of the shelf). A wide section has 45° overhangs leading to it, so it printed without support for me. You could add support to the build plate.
Inclides OpenSCAD source file.
(Yes, that's a side-mounted foot on the printer, for accessing the motherboard and power supply. Maybe I'll post the bracket and foot for that project.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
