Thingiverse
Wire Spool Holder
von cmillionbrown
6
Downloads
2
Likes
0
Makes
Wire spool holder that can accommodate up to 3 rolls with a width of 1.35" each. Wire spool center hole must be larger than .75". Wire spool cannot have a diameter larger than 2.75".
You will need to print 2 halves of the roller and glue them together- I used 2 part epoxy and it's holding up great.
Printed on an Ender 3 V2 using [these](https://i.imgur.com/kcrdpJ1.jpg) Cura settings. Your settings can probably be faster.
You will need to print 2 halves of the roller and glue them together- I used 2 part epoxy and it's holding up great.
Printed on an Ender 3 V2 using [these](https://i.imgur.com/kcrdpJ1.jpg) Cura settings. Your settings can probably be faster.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
