Wire Spool / Spindle

Wanted a basic spool for wire I buy for guitars that comes off-spool. Spool gap (?) is about 30mm wide and 25mm deep. Very simple print, no supports, 15mm hole through middle, small hole to start the wire in, small notch to align the two halves together. Holds pretty well, but was designed to glue together with a few drops of CA glue. Obviously can resize easily.

Printed with a brim at 10 lines, 10% infill even though most of the print is solid walls.

Photo has 10m of 7-strand pushback wire on it.