Thingiverse
Wireframe Cat
door Coolkid171717
1
Downloads
0
Likes
0
Makes
This is a wireframe Cat that i made.,
It prints without any supports.
I printed mine at 0.2mm and it came out looking great.
when printeing, first slice the STL, then check the very first layer. If its not perfectly on the bed change the z position value to -1 so it goes into the bed a bit. This will give your a better starting layer.
It prints without any supports.
I printed mine at 0.2mm and it came out looking great.
when printeing, first slice the STL, then check the very first layer. If its not perfectly on the bed change the z position value to -1 so it goes into the bed a bit. This will give your a better starting layer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
