MakerWorld
Hueforge & Lithophane
Zum Modell
Witcher vs Werewolf
12
Downloads
21
Likes
5
Makes
Project: Witcher vs WerewolfPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmThis print uses 7 unique filamentsPLA BambuLab Basic Black PLA BambuLab Matte Dark Blue PLA BambuLab Basic Blue Gray PLA BambuLab Basic Blue Cyan PLA BambuLab Basic BrownPLA BambuLab Matte Desert TanPLA BambuLab Matte Ivory WhiteSwap Instructions:Start with BlackAt 0.72mm swap to Dark BlueAt 0.88mm swap to Blue GrayAt 1.12mm swap to Blue CyanAt 1.28mm swap to BrownAt 1.68mm swap to Desert TanAt 1.92mm swap to Ivory White for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
