Witches 3

The model is on the smaller side and can be turned into a fridge magnet using magnetic tape. I did not add magnet insert points because it is very thin. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 100x100mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #8 (0.72mm) swap to Orange At layer #14 (1.2mm) swap to Yellow At layer #22 (1.84mm) swap to Jade White for the rest.