Wool winder

**Project repository:** https://github.com/FarK/winder

Wool Winder
==========

This project consist in a series of 3D printed pieces for assembly a wool
winder. It is based on a couple of existing project and comercial products
[1][2][3].

All the pieces was design for an easy print. No support is needed.

All was design in OpenScad[4] and there is a lot of customizable parameters,
like the gears size and angle, the bearing and threading rod radius, the screw
holes radius, etc. You can find all these parameters at the header of the
`winder.scad`.

https://www.youtube.com/watch?v=sXUekIx7C48

Generation
==========
The easiest way for generate all the pieces is use the provided makefile. After
launching the `make` command, you should find all `*.stl` inside a folder
named `stl/`. There is an "special" `all.stl` which contains all the pieces
spread in a plane. There is another make target, `make images`, for generate a
folder with two images of each piece, one nor