Thingiverse
WOPR Computer Model
von BrianEnigma
229
Downloads
211
Likes
11
Makes
This is a model of the WOPR computer from War Games. The model was manually reconstructed by watching the same 39 seconds of the film over and over again. I took a few liberties in the rebuild.
(1) The recessed hatches and/or the overall length are not quite to scale (there actually should be a group of four rivets after the pair of panels).
(2) The real movie prop has a bit of an overhang at the floor, whereas I made the sides go straight down to the floor for easier MakerBot and RepRap printing.
(3) I made no attempt to model das blinkenlights.
(4) I only reproduced the large text.
(5) There may be an Easter Egg inside the hollow base for fans of TRON.
Slightly more detail on my blog: http://netninja.com/2012/08/03/is-that-a-wopr-in-your-pocket/
(1) The recessed hatches and/or the overall length are not quite to scale (there actually should be a group of four rivets after the pair of panels).
(2) The real movie prop has a bit of an overhang at the floor, whereas I made the sides go straight down to the floor for easier MakerBot and RepRap printing.
(3) I made no attempt to model das blinkenlights.
(4) I only reproduced the large text.
(5) There may be an Easter Egg inside the hollow base for fans of TRON.
Slightly more detail on my blog: http://netninja.com/2012/08/03/is-that-a-wopr-in-your-pocket/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
