Word Clock

Word clock made with neo pixels, arduino nano, tiny GPS and a RTC (ds1307)

Dose require a large wide bed to print,

neopixels 60 per meter fit perfectly behind each letter.

If you have a CNC use the no front 3D prints and CNC out of 3mm perspects using the CNC letter.tap,
use perspects colour of you choice, i use black as it give a nice mirror finish when you use smooked black perspects in front of it.

button on side is used to change colour but this is done every hour, and a quick double tap will show the date.

On the Nano pin A3,A4,A5 connect to the RTC, pin 6 is to the neo pixels, pin 5 is the button, pin 7,8 is serial for GPS and 9 is for the power on of GPS(only there for rebooting the GPS so is not required for it to work, GPS can but feed off 5v directly)

On boot the display will cycle through every colour on every neopixel, then while it is waiting for signal it will go into a matrix show, the matric show also shows for 1 min at 1 min past the hour,
on the