Thingiverse
Workzone Titanium 2x Nut Setter + Driver Holder (ALDI)
di AJthecarguy
4
Download
3
Likes
1
Makes
This is a re design of my Driver Bit holder for Makita 18v tools to fit on ALDI's Workzone Titanium 20v Drill and Driver. This holder was designed with wider spacing than my other standard 3 Piece Holder to hold a 5/16 and a 3/8 Nutsetter bit along with 1x Driver bit as shown in photos
This holder is able to hold the same 3 Piece Socket adapter kit as my Makita version but the 1/2 inch adapter cannot be slide into the holder all the way due to the tapered design of the tool. You can see this in the attached Photos. I may re design to fix this at some point.
Check out my other items for alternate designs.
It is held in place by a single 15mm M3 bolt or the bolt that is already part of the Workzone Tool.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desir
This holder is able to hold the same 3 Piece Socket adapter kit as my Makita version but the 1/2 inch adapter cannot be slide into the holder all the way due to the tapered design of the tool. You can see this in the attached Photos. I may re design to fix this at some point.
Check out my other items for alternate designs.
It is held in place by a single 15mm M3 bolt or the bolt that is already part of the Workzone Tool.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desir
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
