Thingiverse
Workzone Titanium 3x Bit Holder (ALDI)
door AJthecarguy
7
Downloads
1
Likes
1
Makes
This is a re design of my Driver Bit holder for Makita 18v tools to fit on ALDI's Workzone Titanium 20v Drill and Driver. This holder can store 3x 1/4 inch hex Driver Bits of different lengths.
Check out my other items for alternate designs.
It is held in place by a single 15mm M3 bolt or the bolt that is already part of the Workzone Tool.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desired fit is achieved
The example shown in the photos is printed in PLA above 80% infill and seems to be more than strong enough for home / garage DIY work.
Print this holder standing on its end.
If you wish to have the holder on the opposite side of the tool just Mirror the model in your slicing software.
Check out my other items for alternate designs.
It is held in place by a single 15mm M3 bolt or the bolt that is already part of the Workzone Tool.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desired fit is achieved
The example shown in the photos is printed in PLA above 80% infill and seems to be more than strong enough for home / garage DIY work.
Print this holder standing on its end.
If you wish to have the holder on the opposite side of the tool just Mirror the model in your slicing software.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
