Thingiverse
Learning
Zum Modell
Worm reductor
39
Downloads
59
Likes
0
Makes
This is a model of a worm reductor i made. It is fully printable with the exception of M3 bolts holding the housing togeder.
i used supports when printing the gear and the worm. i had to do a little clean up afterwards, but i still got a tight fit.
i used supports when printing the gear and the worm. i had to do a little clean up afterwards, but i still got a tight fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
