WS2811 Pixel 24" Sitting Easter Bunny

This is an Easter Bunny prop designed to be used with WS2811 Addressable Bullet Pixel LEDs. This prop stands 24" tall and uses 39 bullet pixels. It is a modular design that prints on a 256x256mm print bed with friction fit dovetails to assemble (no glue necessary). All joints are labeled for easy assembly. It is recommended to assemble the prop on a hard level surface as some force is necessary to fit the pieces together. It is designed to be staked in the ground using garden staples (Link to what I used below). This can be set up to run in both XLights as well as WLED. I've included my recommended setup for both, but feel free to adapt it to your preference. WLED Setup:Single Segment of 39 Pixels Xlights Setup:Circle with 39 Nodes (Start and end where it works for your setup) Garden Staple Link:https://www.amazon.com/dp/B096SW5TQ1