Thingiverse
WWE Ring
von swedishmale
16
Downloads
42
Likes
0
Makes
A WWE ring , very easy to print, no supports needed.
You can scale it if you need it.
Print orientation of ring arms pictured.
2xm3 screws, or super glue to fasten each ring arm.
Usa whatever material you'd like, but I used PLA-CF for ring arms to increase its mechanical properties.
The red rope in the picture is TPU which I cut to use.
You can scale it if you need it.
Print orientation of ring arms pictured.
2xm3 screws, or super glue to fasten each ring arm.
Usa whatever material you'd like, but I used PLA-CF for ring arms to increase its mechanical properties.
The red rope in the picture is TPU which I cut to use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
