Thingiverse
X-Axis Endstop Bracket
door badrock
26
Downloads
15
Likes
0
Makes
This bracket was made to fit the MendelMax 1.5 X-axis using the Pillow Blocks from Lulzbot (https://www.lulzbot.com/ACME-Pillow-Block-X-End-Set-2.0). The clamps fit tight on to the 8mm X-Axis rods to eliminate possible movement of the endstop.
The endstop mount is derived from the X-axis mount from here http://www.thingiverse.com/thing:181468. I modified the height to lower the endstop to be closer to the rods and moved the clamps to fit the spacing requirement.
The endstop mount is derived from the X-axis mount from here http://www.thingiverse.com/thing:181468. I modified the height to lower the endstop to be closer to the rods and moved the clamps to fit the spacing requirement.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
