Thingiverse
X limit switch support
von andregr95
5
Downloads
1
Likes
0
Makes
Supports are included in the stl model
06/12/21
Support v2 version has been uploaded:
- It's 4mm lower and a little bit tighter
- The board is now supported along its entire length
- Many edges has been rounded
06/12/21
Support v2 version has been uploaded:
- It's 4mm lower and a little bit tighter
- The board is now supported along its entire length
- Many edges has been rounded
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
