MakerWorld
Hueforge & Lithophane
Zum Modell
X-Men Cyclops
1
Downloads
16
Likes
1
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 115x160mm in size You may print at higher layer heights below the Min Depth of 0.88mm The Max Depth is 2.2mm and the Actual Depth is 2.2mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Blue Transmission Distance: 4 PLA Kingroon Red Transmission Distance: 4.1 PLA BambuLab Basic Yellow Transmission Distance: 5.9 This print uses 5 unique filaments Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Gray At layer #14 (1.2mm) swap to Blue At layer #18 (1.52mm) swap to Red At layer #24 (2mm) swap to Yellow for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
