Thingiverse
X_Tend spool bracket
von linsperf
3
Downloads
2
Likes
0
Makes
X_Tend spool bracket, designed to be a side mount spool extension bracket for all ender 3 series printers
Hardware needed:
(3) m5x10mm long socket head screws, (2) m5 nuts & (1) m5 t-nut
Slicer Settings:
LAYER HEIGHT: 0.2, WALL LINE COUNT: 4, TOP & BOTTOM LAYERS: 4, INFILL: 35% PATTERN: Octet, TRAVEL: combing mode: ON setting: not in skin, SUPPORT: no, Material: PLA
Hardware needed:
(3) m5x10mm long socket head screws, (2) m5 nuts & (1) m5 t-nut
Slicer Settings:
LAYER HEIGHT: 0.2, WALL LINE COUNT: 4, TOP & BOTTOM LAYERS: 4, INFILL: 35% PATTERN: Octet, TRAVEL: combing mode: ON setting: not in skin, SUPPORT: no, Material: PLA
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
