Xbox controller Wall Mount

Remixed as the original had quite a chunky profile.The arms have been given an extra 2mm as the original ones were a bit flimsy.Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).Update:I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green filament :)UPDATE:I have added 2 more screw holes due to the legs pulling on the top of the frame which pulls it away from the wall/table. Also reversed one of the legs due to the same reason.Category: Video Games