Thingiverse
xbox one controller holder
by anticolette
46
Downloads
64
Likes
0
Makes
THIS EXACT VERSION HAS NOT BEEN TESTED YET PLZ GIVE ME FEEDBACK
- UPDATE 2017/11/21 : corrected file upload and enlarged a little bit
- UPDATE 2017/11/21 : corrected radius
An Xbox one controller holder design to hold a controller WITHOUT its cable, against a vertical surface.
Hole are designed to match 4mm metric pegboards (25 mm * 4mm holes) (6mm holes can be drilled if needed).
It is designed to be printed without support (I would recommand rotating it with the big flat surface facing the bed)
The design is almost fully parametric and can be adjusted very easily with fusion 360, here is the link to the latest version : http://a360.co/2zVXEvW
- UPDATE 2017/11/21 : corrected file upload and enlarged a little bit
- UPDATE 2017/11/21 : corrected radius
An Xbox one controller holder design to hold a controller WITHOUT its cable, against a vertical surface.
Hole are designed to match 4mm metric pegboards (25 mm * 4mm holes) (6mm holes can be drilled if needed).
It is designed to be printed without support (I would recommand rotating it with the big flat surface facing the bed)
The design is almost fully parametric and can be adjusted very easily with fusion 360, here is the link to the latest version : http://a360.co/2zVXEvW
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
