Xbox One mini wheel Evolution

The four year old design has been remastered for greater driving precision, faster printing and 97% less support material.

https://www.youtube.com/watch?v=__txpfj70Nw


What you need:

608 bearing, 22mm diameter, 7mm thick, 8mm center. Get one from that dusty fidget spinner you have laying around...also skateboard bearings

superglue

piece of 1.75 filament/#16 finishing nail/M2 X15mm screw



Print Settings
.2 layer height (.4 nozzle)
0 top/bottom layers

15 walls - makes parts solid

supports are built in [turn them off in the slicer]

Tolerances are tight on this model and good layer adhesion is a must. Make sure your printer is properly calibrated before attempting this project.



Post-Printing
Break off the support piece.

Snap the button into the frame.

Attach the pivot to the rack. 3 methods:

Make a rivet from a piece of 1.75 filament.

Cut down a #16 finishing nail and glue the rack end

M2 X15mm screw.

Glue the top and