Xbox One S Controller Modified

All I have done is made the the button holes wider to help minimize the amount of filing needed.

All credit needs to go to MightMilky for the brilliant scan.


To test:
I edited the file attached to remove the the hand grips and and the screw hole's and just left the holes of where the buttons and analogs go.

Then while i was fitting the original file to my nephews controller i tested the little test print out to see if the buttons feel nicely and results are that it fits with no problem.

Supports:
For the supports I use the experimental feature in Cura of the tree support with this active make sure that you do not have normal supports selected only the tree support is to be selected.

When printing i have had better results with the tree support than i have had with normal supports