Thingiverse
Xbox power brick wall mount
di johnabassian
56
Download
37
Likes
0
Makes
Wall mount for mounting an Xbox One/360 power brick on the wall. Designed for easy removal from wall mounted screws, maximum airflow, and minimum filament.
Printed with 20% fill density and .3mm layer height.
edit: Whoops, I'm a moron. The hole on the bottom is too small for the connector to go through, need to adjust. Do not print this until I get v2 uploaded.
v2: square hole on the bottom big enough to fit the connector. If you've printed v1 already, just use a hair drier to heat the bottom, and fan it out enough to fit the connector through it.
Printed with 20% fill density and .3mm layer height.
edit: Whoops, I'm a moron. The hole on the bottom is too small for the connector to go through, need to adjust. Do not print this until I get v2 uploaded.
v2: square hole on the bottom big enough to fit the connector. If you've printed v1 already, just use a hair drier to heat the bottom, and fan it out enough to fit the connector through it.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
