Thingiverse
xConnect Panel Mount Flat
by jakabo27
80
Downloads
19
Likes
0
Makes
I made a mounting device for the popular 3-core xConnect connector. This connector is commonly used for advanced Christmas light displays to music using xLights or similar software. You can see this [Instructable](https://www.instructables.com/id/Holiday-Light-Show-Synced-to-Music/) I wrote about getting into that kind of show.
The connector I modeled it on is from [Wired Watts](https://www.wiredwatts.com/3-core-xconnect-connector), but they should all be identical.
No supports needed, print two of the mount piece obviously. I recommend printing at 0.2mm layer height.
#Hardware Needed#
- M3 bolts (x2)
- M3 hex nuts (x2)
- Washer for M3 bolts (x2) (optional)
- Normal sized zip-tie (x2)
- Small zip tie (x1) (optional)
#Assembly#
Put the female end of the xConnect pigtail in between the two halves of the part, paying attention to the flat areas so that your connector is vertical. Press them together with your fingers, and attach zip ties as shown in the picture in
The connector I modeled it on is from [Wired Watts](https://www.wiredwatts.com/3-core-xconnect-connector), but they should all be identical.
No supports needed, print two of the mount piece obviously. I recommend printing at 0.2mm layer height.
#Hardware Needed#
- M3 bolts (x2)
- M3 hex nuts (x2)
- Washer for M3 bolts (x2) (optional)
- Normal sized zip-tie (x2)
- Small zip tie (x1) (optional)
#Assembly#
Put the female end of the xConnect pigtail in between the two halves of the part, paying attention to the flat areas so that your connector is vertical. Press them together with your fingers, and attach zip ties as shown in the picture in
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
