Xhover GAPiT Antenna mount
von EvokeFPV
0
Downloads
3
Likes
0
Makes
Xhover GAPiT Antenna Mount
I designed this for a friend as he wanted spares for his GAPiT frame, it's best to print a very high infill as the original one is very stiff, SMA is at 45 degrees the same as the original one so no need for supports, just print as it is.
I designed this for a friend as he wanted spares for his GAPiT frame, it's best to print a very high infill as the original one is very stiff, SMA is at 45 degrees the same as the original one so no need for supports, just print as it is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!