Thingiverse
XP DEUS Pointer holder Bracket
door MontagueFlange
23
Downloads
29
Likes
0
Makes
Needed one didn't like the one on here so made my own. Make sure the XP logo is facing towards the back, and you have the top side of the little bracket that was as well. ( just in case there was a slight misalignment )
You'll need two M4 nuts and bolt, DO NOT over tighten them, The smaller clip is a tight push fit so no need to whack them right up. Just enough to hold the bigger part in place.
Don't come crying to me if you can't do it.
You'll need two M4 nuts and bolt, DO NOT over tighten them, The smaller clip is a tight push fit so no need to whack them right up. Just enough to hold the bigger part in place.
Don't come crying to me if you can't do it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!