Thingiverse
XT60 Parallel Connector Shield
por Bromego
387
Descargas
298
Likes
0
Makes
Simple Solder the ends of 1 female to 2 male XT60 Connectors and slide this over to hold it all together.
For me I drop a bit of hot glue between the two male xt60 connectors to hold it together before soldering. After that just print the shield and drop another little drop inside, and then slide on the shield.
Structural and Safe!
For me I drop a bit of hot glue between the two male xt60 connectors to hold it together before soldering. After that just print the shield and drop another little drop inside, and then slide on the shield.
Structural and Safe!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!