Thingiverse

Y-Axis Direct Drive for CTC Replicator Flashforge

von 3DWorkhorse

138 Downloads

83 Likes

1 Makes

> Recommended for heated build chambers! (to protect stepper from the heat)

Hi folks!

Another upgrade item for your replicator-like 3D printer. It is a mount to drive the y-axis' rod directly without another belt, so there is no additional force on the y-rod (no bending, easier to rotate) and no backlash due to a "loose" belt.
I found that my prints are a bit more precise since the upgrade. Especially the ringing effect (wave pattern after sharp corners) was reduced on the y-axis.

> Why it's mounted on the left side of the printer?
>> The original mounting point and the new one allow the same direction of rotation for the stepper. It can be mounted on the right side too, but then you have to invert the y-axis in the firmware config, which i didn't want to do.

> Why there are 3 versions of the base? What is the difference?
>> All 3 version have different positions for the upper hole of the y-endstop sensor. I found that my CTC printer isn't laser-cutted as precisely as ex

CTC ctc creator ctc printer direct axis direct-drive direct drive flashforge Flashforge Creator heated build chamber heated chamber heated enclosure replicator upgrade y-axis y-axis mod CTC ctc creator ctc printer direct axis direct-drive direct drive flashforge Flashforge Creator heated build chamber heated chamber heated enclosure replicator upgrade y-axis y-axis mod

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat