Thingiverse
yarn holder
by tartaglia3
0
Downloads
0
Likes
0
Makes
whatever you put on this will be able to freely unwind without rolling everywhere
only hardware needed is a 608 bearing
support is only needed on the top half
updated 14/9/2025: added a v2 for the bottom half with an angle since i ran into the part that goes into the bearing breaking off
only hardware needed is a 608 bearing
support is only needed on the top half
updated 14/9/2025: added a v2 for the bottom half with an angle since i ran into the part that goes into the bearing breaking off
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
