Thingiverse
Yet another Hinge
von PrototypeMe
55
Downloads
28
Likes
0
Makes
This hinge is based on a piano hinge
It can be printed flat
The hinge has a 2mm bore and I use 1.75 filament as a pin, this is cut long and melted at each end so it stays in place.
It can be printed flat
The hinge has a 2mm bore and I use 1.75 filament as a pin, this is cut long and melted at each end so it stays in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
