Yet another Lightning Cable Protector

This is a model of a Lightning cable protector (suitable for flexible plastic), made on Rhinoceros, that consists on three pieces, the protector itself and two rings, made for fixing the protector to the cable.
I personally suggest printing the three of them, but the model will work perfectly fine just with the protector itself.
I also recommend reading the print settings down below.


PS: For fixing the protector you'll need to pass the rings first into the cable (the tiny one will get in with some force and the bigger one will pass though just fine), and then place the protector in the final place, fasten the rings on position and its ready to go!.