Yet Another Mini Storage Solution

Since I've been printing all of these minis for Gloomhaven, I realized that I needed a good way to store and transport them. There are a bunch of excellent mini storage solutions out there, but I'm picky and wanted one that was slightly different, so I designed yet another one.

This one is designed to fit inside of a plastic tote box that I got at Costco in a six pack. 2 trays fit side by side (I set them on a towel because the bottom of the tote isn't flat), and at least 2 can stack on top of each other. I made these to stack with 5 cm of vertical clearance between the two layers, since so many Gloomhaven monsters are 1.5 x human height.

This tray is built for minis with a 25 mm base and fits them snugly enough that they can't lift out of their tracks but they still slide in easily. I tapered the tops of channels that hold the minis in place at 45 degrees so that the whole thing is printable without supports. As you might expect, it fits my 25 mm numbered bases just fine =)