Thingiverse
Yongnuo YN360 Light Diffuser
por fallschirm
1
Descargas
1
Likes
0
Makes
This is a diffuser for Yongnuo YN360 (square body). The YN360 comes with a orange diffuser which does not meet my needs. Thats why I created this slide on white diffuser from PETG.
It was printed on an Anycubic Mega X (300x300mm) and was 45° angled to fit the printbed.
For the best diffusing results I recommend 3D cross infill at 30% infill amount.
I printed with 260°C and 80°C bed in an enclosure, you might need to tweak these settings to get propper adhesion. 40mm/s seemed to work pretty well and gave good results in an acceptable time (~8 hours). I used 0.2mm layer height.
It was printed on an Anycubic Mega X (300x300mm) and was 45° angled to fit the printbed.
For the best diffusing results I recommend 3D cross infill at 30% infill amount.
I printed with 260°C and 80°C bed in an enclosure, you might need to tweak these settings to get propper adhesion. 40mm/s seemed to work pretty well and gave good results in an acceptable time (~8 hours). I used 0.2mm layer height.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
