Thingiverse
Z axis height calibration
door photocromax
36
Downloads
22
Likes
0
Makes
Stands for Z axis level
Print two copies of this thing and you could easliy level yout X carriage.
Put them close to the Z axis motors, they will engage the lower 8 mm X carriage rod
Procedure:
- Jog your Z axis up to 30 mm
- Place the stands on your printer
- Jog your Z axis down until both stands are engaged and pressed by the rod
- Lift Z axis 20 mm
- Remove the stands
- Done, you're ready to print or level your bed :)
Print two copies of this thing and you could easliy level yout X carriage.
Put them close to the Z axis motors, they will engage the lower 8 mm X carriage rod
Procedure:
- Jog your Z axis up to 30 mm
- Place the stands on your printer
- Jog your Z axis down until both stands are engaged and pressed by the rod
- Lift Z axis 20 mm
- Remove the stands
- Done, you're ready to print or level your bed :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
