Thingiverse
Z-Axis Indicators
por Gunslinger59
3
Descargas
3
Likes
0
Makes
Z-Axis indicators for 8mm rods.
These indicators will show you if your Z rods have gone out of sync.
Clip one on each rod (top or bottom). Adjust your Z. Insert screw and nut on each indicator and line them up. Tighten the screws.
If they are out of sync, realign them by turning one of the rods by hand (preferably when the printer is off).
Easy? You bet!
These indicators will show you if your Z rods have gone out of sync.
Clip one on each rod (top or bottom). Adjust your Z. Insert screw and nut on each indicator and line them up. Tighten the screws.
If they are out of sync, realign them by turning one of the rods by hand (preferably when the printer is off).
Easy? You bet!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!