Thingiverse
Z axis support
von SveGo
24
Downloads
13
Likes
0
Makes
Improve the stability of the Z axis using a wooden dowel as a connector.
Will improve z axis stability a lot. Uses a 10mm wooden Dowel for the connection, but any 10mm rod will do.
I used 3x12mm screws for the connection to the woorden board and into the dowel.
I use it on a Tevo Tarantula but will probably work with any printer using a 2020 frame.
Will improve z axis stability a lot. Uses a 10mm wooden Dowel for the connection, but any 10mm rod will do.
I used 3x12mm screws for the connection to the woorden board and into the dowel.
I use it on a Tevo Tarantula but will probably work with any printer using a 2020 frame.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
