Zenitsu and the Moon

Before You Print!If you wish to sell any of these check out my Patreon if you'd like to support my work and get access to sell commercially!Thank you for supporting mewww.patreon.com/fabricate3dprint First, You cannot adjust the z scaling on any hueforge. This will mess with the coloring and won't come out right. If you do want it smaller or bigger you can scale the x and y proportionally to the set sizing either by percentage or length. Each one of my prints will use bambulab filaments unless other wise stated! Don't worry about what you see in the slicer, it is not accurate to how the final results will look as the colors will blend to make it look proper! I Provide a .mf file for each one of these posts that is set up and ready to print. Follow the color code provided at the bottom! Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 125x250mm in sizeYou may print at higher layer heights below the Min Depth of 1.2mmThe Max Depth is