Thingiverse
Zig-Zag Lamp
von Byers3dStuff
206
Downloads
228
Likes
2
Makes
This is a lamp I designed because i didn't really like any that I saw on here.
Here is a list of parts you will need to buy:
Socket: https://www.lowes.com/pd/SERVALITE-250-Watt-Black-Hard-Wired-Light-Socket/3379456
Switch: https://www.amazon.com/Gardner-Bender-GSW-24-Insulated-Electrical/dp/B000LNNUYO/ref=sr_1_8?ie=UTF8&qid=1545373681&sr=8-8&keywords=lamp%2Bbutton%2Bswitch&th=1
Cord: Any cord will work.
Instructions:
Make sure to print the Lamp_Shade in vase mode, without supports. The Lamp_Base needs supports.
Connect the wire of the wide prong to the white wire of the socket, then connect the wire of the narrow prong to one end of the button, finally connect the other end of the button to the black wire of the socket.
Please post your makes!
Here is a list of parts you will need to buy:
Socket: https://www.lowes.com/pd/SERVALITE-250-Watt-Black-Hard-Wired-Light-Socket/3379456
Switch: https://www.amazon.com/Gardner-Bender-GSW-24-Insulated-Electrical/dp/B000LNNUYO/ref=sr_1_8?ie=UTF8&qid=1545373681&sr=8-8&keywords=lamp%2Bbutton%2Bswitch&th=1
Cord: Any cord will work.
Instructions:
Make sure to print the Lamp_Shade in vase mode, without supports. The Lamp_Base needs supports.
Connect the wire of the wide prong to the white wire of the socket, then connect the wire of the narrow prong to one end of the button, finally connect the other end of the button to the black wire of the socket.
Please post your makes!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
