Slicer Discord
20 Second Light Timer – Modelo 3D imprimible de MakerWorld MakerWorld
Other Art Models

20 Second Light Timer

13 Descargas
66 Likes
2 Makes
Ver Modelo
When my sister was a little kid, she was scared of vampires. Her nightly routine consisted of pushing the bi-fold closet doors all the way open so no one could hide behind them, hopping into bed and pulling the covers up so they wrapped tightly around her neck, and then she'd stare intently into the closet to make sure no one had snuck in there while she was fussing with the covers. And then she'd beg for one of us to turn out the light. This took about 20 seconds.So if you or someone you know is scared of vampires, or maybe you just need some time to get across the room, this thing's for you. It uses a steel ball that rolls back & forth down a track and then falls in a scoop attached to the light switch lever, turning it off.Oh, and it's also got a bit of interesting physics in getting a ball to roll really slowly.Watch it go at: Requires a 5/8" diameter steel ball and three 6-32 screws.ASSEMBLYTo complete the assembly, you will need:1 5/8" diameter steel ball3 6-32 x 3/8" long socket
Categoría
Other Art Models
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

LoboCNC también publica en

313 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección