Slicer Discord
20 Second Light Timer – 3D-printbaar model van MakerWorld MakerWorld
Other Art Models

20 Second Light Timer

13 Downloads
66 Likes
2 Makes
Model downloaden
When my sister was a little kid, she was scared of vampires. Her nightly routine consisted of pushing the bi-fold closet doors all the way open so no one could hide behind them, hopping into bed and pulling the covers up so they wrapped tightly around her neck, and then she'd stare intently into the closet to make sure no one had snuck in there while she was fussing with the covers. And then she'd beg for one of us to turn out the light. This took about 20 seconds.So if you or someone you know is scared of vampires, or maybe you just need some time to get across the room, this thing's for you. It uses a steel ball that rolls back & forth down a track and then falls in a scoop attached to the light switch lever, turning it off.Oh, and it's also got a bit of interesting physics in getting a ball to roll really slowly.Watch it go at: Requires a 5/8" diameter steel ball and three 6-32 screws.ASSEMBLYTo complete the assembly, you will need:1 5/8" diameter steel ball3 6-32 x 3/8" long socket
Categorie
Other Art Models
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

LoboCNC publiceert ook op

313 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie