Thingiverse
Armattan Rooster - wire holder - arms
by idcrash
19
Downloads
15
Likes
0
Makes
Hi,
here comes a simple but nice wire holder for the arms of a armattan rooster if you use a 4in1 esc. print it in TPU (i used sainsmart) ant slide it on one end of the arm. its really tight but strong enough to strech it so wide. perhaps use som water or spit ( :D ) to get it over.
the hole is about 5mm. i printed it standing upwards using support in the holes.
Gl & Hf
Likes, tips or just a loud "Thank you", are welcome :D
here comes a simple but nice wire holder for the arms of a armattan rooster if you use a 4in1 esc. print it in TPU (i used sainsmart) ant slide it on one end of the arm. its really tight but strong enough to strech it so wide. perhaps use som water or spit ( :D ) to get it over.
the hole is about 5mm. i printed it standing upwards using support in the holes.
Gl & Hf
Likes, tips or just a loud "Thank you", are welcome :D
Sign in to leave a comment
Sign in