7 inch Touchscreen Case

Case for a 7 inch touchscreen commonly found on Amazon, this is the screen that has the standoffs on the rear of the screen, not the screens with the tabs sticking out. The case is not designed to have a Pi inside of the case, however, a Pi Zero may fit inside the case, this is untested and not the intention of the design.

The recessed section is designed to fit 30mmx30mm fans to keep your screen cool.

The holes with standoffs are designed to fit M2.5x25 laptop screws, this was designed based on the thread spec of my screen in particular. Additionally, the four small holes in the square pattern are spaced for VESA 75x75, I would recommend the heat seat threaded inserts designed for 3d printed parts.

The rectangular holes labeled HDMI/PWR are intended to be large enough to pass an HDMI and Micro USB cable through respectively to connect to a velcro attached Pi or other source.