Thingiverse
Adjustable Locking Joint
par CentaurDesign
265
Téléchargements
218
Likes
0
Makes
This is an adjustable locking joint designed to work with PVC tubing and hardware for the purpose of creating an adjustable-height laptop stand.
Each joint requires the following hardware:
1/4" Carriage bolt 2 1/2" long
1/4" Wing nut for the carriage bolt
5/16" Diameter Compression Spring approximately 2" long
For the stand, 1/2" PVC tubing was used. Patterned duct tape was added to the pvc tubing for aesthetics. The "table" surface for the laptop was woven from paracord.
Designed by Ralph, a high school Drafting & Design student, using Solid Edge.
Each joint requires the following hardware:
1/4" Carriage bolt 2 1/2" long
1/4" Wing nut for the carriage bolt
5/16" Diameter Compression Spring approximately 2" long
For the stand, 1/2" PVC tubing was used. Patterned duct tape was added to the pvc tubing for aesthetics. The "table" surface for the laptop was woven from paracord.
Designed by Ralph, a high school Drafting & Design student, using Solid Edge.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
