Thingiverse
Adjustable Locking Joint
door CentaurDesign
265
Downloads
218
Likes
0
Makes
This is an adjustable locking joint designed to work with PVC tubing and hardware for the purpose of creating an adjustable-height laptop stand.
Each joint requires the following hardware:
1/4" Carriage bolt 2 1/2" long
1/4" Wing nut for the carriage bolt
5/16" Diameter Compression Spring approximately 2" long
For the stand, 1/2" PVC tubing was used. Patterned duct tape was added to the pvc tubing for aesthetics. The "table" surface for the laptop was woven from paracord.
Designed by Ralph, a high school Drafting & Design student, using Solid Edge.
Each joint requires the following hardware:
1/4" Carriage bolt 2 1/2" long
1/4" Wing nut for the carriage bolt
5/16" Diameter Compression Spring approximately 2" long
For the stand, 1/2" PVC tubing was used. Patterned duct tape was added to the pvc tubing for aesthetics. The "table" surface for the laptop was woven from paracord.
Designed by Ralph, a high school Drafting & Design student, using Solid Edge.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
