Anet A8 Sensor Bracket

For everybody that doesn't fit with Leo_N's bracket because it's too big and the sensor is not perpendicular to the plate.
12mm version tested and working, 18mm version to test but I think it's working.

Settings for skynet firmware:

Offsets for 12mm sensor:

define X_PROBE_OFFSET_FROM_EXTRUDER -22 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER -36 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]

define LEFT_PROBE_BED_POSITION 25
define RIGHT_PROBE_BED_POSITION 195
define BACK_PROBE_BED_POSITION 170
define FRONT_PROBE_BED_POSITION 20

Offsets for 18mm sensor:

define X_PROBE_OFFSET_FROM_EXTRUDER -26 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER -40 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]

define LEFT_PROBE_BED_POSITION 25
define RIGHT_PROBE_BED_POSITION